Traditional Garage Door Opening

1. Measure the exact width of the garage door opening (from door jamb to door jamb, not from the weather strips). Make no allowances.
2. Measure the exact height of the garage door opening (from the door header, not the weather strip, to the floor). Make no allowances.
3. Place your Garage Door Screen order here.

Please note: KITTY MAC IS NOT RESPONSIBLE IF THE MEASUREMENTS ARE INCORRECT. PLEASE MEASURE CAREFULLY.

Click here to view garage door screen installation videos.

Custom Angle Garage Door Opening

1. Measure total width of garage door opening (from door jamb to door jamb, not from the weather strips). Make no allowances.
2. Measure height at highest point (from the door header, not the weather strip, to the floor). Make no allowances.
3. Measure the height where the angle begins (both right and left side). These measurements should both be the same size, but may not be.
4. Measure angle areas (both right and left side). These measurements should both be the same size, but may not be.
5. Measure distance between top of the angles. NOTE: The screen will have zippers as indicated by the BLUE lines and will roll up in between the angles.
6. Place your Garage Door Screen order here.

Please note: KITTYMAC IS NOT RESPONSIBLE IF THE MEASUREMENTS ARE INCORRECT. PLEASE MEASURE CAREFULLY.

There is an additional $35.00 charge for angled screens.

Click here to view garage door screen installation videos.